Update 6.0.33

Asked by Byron_New2026 on October 6, 2026 - 3 replies

So I’ve updated to 6.0.33 all seem well till I shut the pc down (I’m thinking of leaving it on all time now) I got this issue this morning I was unable to exit via ALT + F4 so I powered off the pc then when it started back up digital canter works normal anyone else had issue?

3 replies

JustanotherAdam - October 6, 2026

Seems you can push it to update to 6.0.34 ... Rick mentioned this on the 6.033 release thread ...

You do not have to wait for the next release. You can get 6.0.34 now in Administration under Updates by pressing "Check now" and then "Install update".

Mark Norville - October 6, 2026

As Adam has said, it is now fixed, but I am not sure why you cannot exit on ALT + F4 as that worked for myself.

My quit program was set to escape key, which is what never worked. However, Alt + F4 was not an issue.

You could also do ctrl + alt + delete and bring up task manager and then select Zenpoint and then close program

Doing a hard reset on your PC is very bad.

Regards

Mark

Byron_New2026 - October 8, 2026

Updated to version 6.0.34 still having the same issues

Read the full thread or browse the forum.